• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Intake Manifold Bolts Question

Chief Master Sergeant

Retired U.S. Air Force
Joined
Nov 6, 2002
Messages
5,222
Got in a hurry this morning when installing the manifold and forgot to put anti-seize on the bolts. It's already torqued down. Will it hurt anything to take the bolts out one at a time, apply the anti-seize and torque them back? Or should I just leave well enough alone and worry about it later?
 

GDTorx

Jr. Member
Joined
Jan 18, 2012
Messages
51
Loc.
Bluemont
Got in a hurry this morning when installing the manifold and forgot to put anti-seize on the bolts. It's already torqued down. Will it hurt anything to take the bolts out one at a time, apply the anti-seize and torque them back? Or should I just leave well enough alone and worry about it later?

My thought would be to just let it be and check torque a couple of hundred miles down the road. Lots of opinions out there that you shouldn't even use anti-seize because it may cause you to over-torque.
 

bronconut73

Bronco Guru
Joined
Aug 7, 2012
Messages
9,919
If the anti sieze being on there becomes important to you I am pretty sure careful removal/reinstallation of each fastener should not be a problem. ......but you already knew that.

Those aren't aluminum heads are they?
If so I would use the anti sieze.
 
Top