I have a Kentrol tub my dad purchased in the mid-90's. Overall finish was pretty good, reinforcement was poor in my opinion. Seeing the internal frame Bronco Design incorporates I can say for sure that I would have been happier with their tub for that reason alone. The tub I have sat until about 2011 when I got serious about finishing the project. When I read the Kentrol installation instructions it had a addendum in it that referenced a problem with fitment. Something like "if you find that the hard top does not fit correctly please call for special instructions to correct the issue" Basically they knowingly sold bodies that had form or fitment issues.
Everything on my 73 is glass except for the windshield frame and it all took some work to achieve a proper fit, some pieces more than others. I have a Bronco Design hood and it is artwork, it's two panels put together so the inside is as nice as the outside. Very well built and fit great but it did take some time to fit the hinges, etc...
I spent many, many hours working the body, fitting the doors, grill, tailgate, dash, etc.. but in the end I don't think it was any more work than if I had removed and replaced the typical rusted panels with new steel ones. I'm happy with the fit and finish I achieved with the Kentrol body, BD hood and the doors, tailgate & grill that I picked up used and don't know the manufacturers. Most people are surprised that it's all glass which is a compliment and testament to the work put into the body. I don't believe that piecing together a steel body or installing a fiberglass one should be something that anyone would expect to be bolt on and go.
I'm with the others here, if there are issues please share and convey in a constructive way so that we can all be more informed and the builder aware of any issues that could potentially be fixed. Throwing out a comment about issues with a respected vendor and not detailing what they were really calls into question the means and methods you used and your skill level every bit as much as the problems with the product. Clear the air and state the issues.