bob_lafrentz
Sr. Member
Hi all,
I recently called Lokar about a flexible engine dipstick. I have the original 1969 302 oil pan with the push in dipstick. They said I needed part number ED5013 and so I purchased it.
The bottom 1/2 of it should push into my oilpan. But, just above the 1/2 mark, the push in ferral gets larger in diameter and has two rubber O-rings imbedded in it. It makes sense that these should push into the oil pan and create an oil-tight seal. But, the diameter of the ferral at this point is too large.
So, my question is this: Is this the model number you used and if so, did you just push it in as far as you could and then sealed it with silicone rubber?
Thanks.
I recently called Lokar about a flexible engine dipstick. I have the original 1969 302 oil pan with the push in dipstick. They said I needed part number ED5013 and so I purchased it.
The bottom 1/2 of it should push into my oilpan. But, just above the 1/2 mark, the push in ferral gets larger in diameter and has two rubber O-rings imbedded in it. It makes sense that these should push into the oil pan and create an oil-tight seal. But, the diameter of the ferral at this point is too large.
So, my question is this: Is this the model number you used and if so, did you just push it in as far as you could and then sealed it with silicone rubber?
Thanks.











