I guess I'm kind of jaded being here in AZ we usually dont see much water when out wheeling so we tend to forget about maintaining things after water crossings. Long story short was at the bronco stampede on a trail run found out my front axle wouldnt engauge so I ran the whole trail in 2wd. Took my drivers side hub apart today and found that I had some rust in the hub and the inner clutch wouldnt move. Took awhile to get the clutch out of the hub cleaned it all out and its working once again.
Thinking back the last time I did any water crossings was at last years Stampede when the river was way high.
So to all you other bronco nuts that went to the stampede this year and did any water crossings you may want to pull your hubs and make sure there's no water inside. You may even want to check your diffs for any water as I know the water at one crossing was over the top of the diffs if you have 33in or smaller tires. Might even apply for those with 35's or larger doesnt hurt to check.
Thinking back the last time I did any water crossings was at last years Stampede when the river was way high.
So to all you other bronco nuts that went to the stampede this year and did any water crossings you may want to pull your hubs and make sure there's no water inside. You may even want to check your diffs for any water as I know the water at one crossing was over the top of the diffs if you have 33in or smaller tires. Might even apply for those with 35's or larger doesnt hurt to check.











