Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
If you have problems registering or can't log into your account, please contact Admin.
Currently i have a 5.5” lift with 35” tire looks great but its “ blocked up” previous owner. Gears were never changed... rides poorly.... can i keep the stock gears with 2.5” lift and 30” tires? Recommendations appreciated
You would probably be much happier with the smaller tires as far as less wear on the drive train with stock gear's. The smaller lift doing lift will most likely be a nicer ride, depending on the spring rate you run on the lift springs., But you will get less axle wrap when you get rid of the blocks.
Some of the stuff done with a tall lift like that should be very easy to return down to a more reasonable lift. But depending on what the PO did during the install, some stuff might be harder.
You'll need to look at anything that was welded on, such as custom steering and suspension linkages, shock mounts and rear axle brackets and radius arm stuff.
With luck, it was done poorly and it'll all just come right off without arguing.
Sure/Maybe/Probably.
Depends on what was stock for yours, 3.50 or 4.11 and what transmission you'll be using and how the engine runs.
But generally speaking with the 3.50's and 30" tires you'll be in the sweet spot for a reasonably good running engine.
Get rid of the blocks and see what spring lift you got. Need more pics of your front linkages and tracbar setup to get an idea of what you will need to do. Keep in mind that a stock suspension is approx. 7" from top of axle to bottom of frame.
Yep, new springs, shorter shocks, potentially shorter driveshafts, maybe shorter brake hoses, and stuff like that.
Definitely post up some pics of the existing steering linkage and the rear leaf springs too.