Slow but steady. We are making progress. I hope to put in a few hours on it tomorrow. We cut all the items off the frame that were no longer needed, such as the radius arm mounts, motor mounts, shock and spring towers. And that POS tow bar thing is going tomorrow too!
I measured and marked up the Heidt's crossmember and took it to work this morning to cut into it with the plasma cutter. I went the extra mile and set it up in the CNC mill and trued it up. I was surprised how close Dennis (hot rod guru!) was able to get using the plasma cutter. It was well within .030 on every line. It will sit exactly (+ or - .005) 3 1/2" from the center of the lower control arm bolt center line.
We left just enough in the center to grind it and get a tight fit between the frame rails, as Heidt's suggested. "It is easier to remove material than it is to add it back on".
I am pretty excited about getting this set it tomorrow. It almost looks too easy, and I am sure we will have a few obsticles to overcome before it it welded in completely. As always, I will update with pics when I get back home tomorrow night. Stay tuned...