behemoth
Bronco Guru
- Joined
- Jul 2, 2003
- Messages
- 1,736
small update today.
The front coil overs are in much easier to install than the 13" long coils that I had in there before. Very light spring rate, a little concerned now on this route.
The main run of fuel and brake lines are done, the interesting part for the brake line was clearing the rear 4 link connection at the rear axle. There will be some fun with the fuel lines but not to that extent.
The fuel lines to the front are fun as well, I will be cleaning up the angles to the floor and run them up to the outside edge of the steering column support.
The fuel filter will be there attached to the brake booster and run steel braded hose from there to the back of the intake.
I need to pick up an external oil filter kit then install the steering lines and steering shaft.
The upper ball joint nut will not go tight, the ball joint spins before it goes tight, this may be another problemo.
The front coil overs are in much easier to install than the 13" long coils that I had in there before. Very light spring rate, a little concerned now on this route.
The main run of fuel and brake lines are done, the interesting part for the brake line was clearing the rear 4 link connection at the rear axle. There will be some fun with the fuel lines but not to that extent.
The fuel lines to the front are fun as well, I will be cleaning up the angles to the floor and run them up to the outside edge of the steering column support.
The fuel filter will be there attached to the brake booster and run steel braded hose from there to the back of the intake.
I need to pick up an external oil filter kit then install the steering lines and steering shaft.
The upper ball joint nut will not go tight, the ball joint spins before it goes tight, this may be another problemo.











