- Joined
- Oct 14, 2004
- Messages
- 5,001
I need to relocate the crossmember for the torque tamer about 3 to 4 inches farther back on the frame. The attachments to the axle are fixed and the adjustment is not going to allow the shackle part to reach after I move it. I think the torque tamer bar would still clear but is close for comfort. I need to make longer shackle connection or shorten the end of the bar 3 to 4 inches, or possibly both. Does anybody see any problems with this modification and it still functioning like it's intended? I really want this back under there as all my wheel hop went away after it was installed. Been running it a few years.
If I put the crossmember back in original location I hits the plug for putting in gear oil.
edit - sorry, pic is upside down, tried unsuccessfully to fix
If I put the crossmember back in original location I hits the plug for putting in gear oil.
edit - sorry, pic is upside down, tried unsuccessfully to fix











