• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Narrowing a full width HP 44

rainerje

New Member
Joined
Feb 15, 2004
Messages
1
Loc.
Florida
I have been searching the archives here on this subject for a few days now. Still looking for more info.

Can a full size HP 44 front (78-79 Bronco) be cut down to EB width without having to cut the passenger side radius arm wedges off and re-welding?

Have seen responses yes and no.

Where will I find the measurements necessary to do this?
I do not have an EB44 to start with.

A HP44 sure would be nice to go with that Currie 9" I just swapped in the rear.

Any help is greatly appreciated!
 

Amac70

ME
Joined
Mar 27, 2002
Messages
3,269
i dont' have the link anymore but to narrow it you don't have to remove the c mounts. i believe you pull the knuckle hack off the 6 inches and weld it back on.
 

broncnut

Sr. Member
Joined
Jul 25, 2001
Messages
429
You only have to cut down the passenger side. Now is a good time to install one of Chucks wristed axle housings. (WAH) This is what I am having done.

Terry
 

g-money

Sr. Member
Joined
Mar 5, 2002
Messages
734
Loc.
Vancouver, WA
I did this last year. I actually had a shop do it since it's beyond my ability. The prefered axle is the one that has the wedges welded on but I used one that had the cast wedges and it works fine. You just need to cut down the passenger side only. You remove it from the pumpkin cut it down and weld it back in.
You need to cut about 6 inches off. The exact measurement I am unsure of. I was told if you cut it down 6 inches you won't be able to fit a stock bronco axle in there ( which I wanted for emergency replacement issues). It will be just a little off. I was told that you need to use a stock bronco axle to get the right measurement. I took a stock axle to the guy who did it and told him I wanted it to fit. Then I had the bigger axles in the HP 44 cut down to match. It cost ma about $700 to get it all done but I took him a clean and painted axles housing. This cost included installing the ARB I provided but he provided all the bearings and shims built the axle from scratch.

The shop that did it is in Oregon and I would definitly recommend them. Let me know if you want the name and number.
Galen
 
Top