• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Nuetral safety switch on c-4 swap

myclsic69

Sr. Member
Joined
Dec 28, 2009
Messages
368
I am doing a c-4 swap from a 3 speed on a 69 uncut ,can anyone guide me on the correct wiring for the 4 prong plug on the nuetral safety switch? I have the 2 existing wires from the Man. trans that controlled the reverse lights. were do the other 2 wires come from? Thanks in advance for all the help.
 

browngr5

Full Member
Joined
Oct 6, 2010
Messages
218
Loc.
Eagle, Idaho
Not sure about the 69 but my 75 has a short 4 wire plug through the firewall just left of the throttle linkage. 2 wires for reverse and the other 2 wires are for the neutral safety switch. Is this where your reverse wires plug into?
 

stupidboy

My wifes porn star.
Joined
Dec 29, 2009
Messages
5,790
Loc.
Morrisdale Pa.
I was told that the other 2 wires don,t exist on the pre 73 models but it is the start cicut that needs interrupted and run through that switch. Hope that helps ya. I am planning the same swap and I am going to cut the Ignition wire that goes to the starter solenoid and run them into it along with the reverse light wires.
 
OP
OP
myclsic69

myclsic69

Sr. Member
Joined
Dec 28, 2009
Messages
368
I was told that the other 2 wires don,t exist on the pre 73 models but it is the start cicut that needs interrupted and run through that switch. Hope that helps ya. I am planning the same swap and I am going to cut the Ignition wire that goes to the starter solenoid and run them into it along with the reverse light wires.

Yea ,my 69 has 2 wires only coming from the harness,which were for the reverse lights, do you have a pic of the wires at the selenoid that you would tie into? Thanks
 
OP
OP
myclsic69

myclsic69

Sr. Member
Joined
Dec 28, 2009
Messages
368
Good luck on your swap! I'm a nuetral safety switch away from starting this Puppy up for the first time since i ripped it apart 3 years ago. and a few $$$$ ago
 

garberz

Bronco Influencer
Joined
Jun 24, 2007
Messages
6,864
Loc.
Conejo Valley, Ca.
It's more accessible to interrupt the wire at the starter solenoid. Just cut the Key start wire, and splice the NSS wires between.
 
OP
OP
myclsic69

myclsic69

Sr. Member
Joined
Dec 28, 2009
Messages
368
It's more accessible to interrupt the wire at the starter solenoid. Just cut the Key start wire, and splice the NSS wires between.

Does spliceing the 1 key start wire ,replace the 2 remaining wires in question to the NSS?
 
Top