• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Only 3 Wheel Drive!!!! Help please?

jeev

Sr. Member
Joined
Feb 13, 2003
Messages
367
Loc.
VEGAS BABY!!!!
Started on my front brake replacement tonight - Just to check things out I locked the hubs and spun the rotors and the drive shaft. (PS its a Dana 44 front) I noticed when I spun the driveshaft only the pasanger side hub was moving... Then I made shure both hubs were locked and tried again - Same thing :- Took a closer look and saw that the drivers side axle was not spinning either - does that rule out bad hub locks? Then I grabed the hubs and turned them individualy - only the pasenger-side turned the drive shaft. The drivers side turned the shaft slowly for a second but if I put any resistance on the drive shaft the hub would turn freely? What does this mean? Thanks
 

justinsane

Full Member
Joined
Apr 25, 2002
Messages
339
Loc.
Casper, Wyoming
Sounds like exactly what would happen if you have a open diff and the DS is dragging. Try holding the PS tire with your foot (or better yet a friend) and turn the drive shaft. If it turns then, your OK, but I would check for dragging brakes or something.

Good Luck,
Brian
 
OP
OP
J

jeev

Sr. Member
Joined
Feb 13, 2003
Messages
367
Loc.
VEGAS BABY!!!!
[quote author=JustinSane link=board=5;threadid=17490;start=0#msg133718 date=1053050178]
Sounds like exactly what would happen if you have a open diff and the DS is dragging. Try holding the PS tire with your foot (or better yet a friend) and turn the drive shaft. If it turns then, your OK, but I would check for dragging brakes or something.

Good Luck,
Brian
[/quote]

Okay - That makes sense. My DS brake caliper is really messed up and it is draging (reson for brake job) and my PS wheel spins too freely (replacing bearing). You made me feel better. Is there a good web page that explaines the working of an open diff? I am going to check how stuff works. Thanks - Could it be anything else?
 
OP
OP
J

jeev

Sr. Member
Joined
Feb 13, 2003
Messages
367
Loc.
VEGAS BABY!!!!
[quote author=JustinSane link=board=5;threadid=17490;start=0#msg133730 date=1053051533]
Try this.

http://www.ring-pinion.com/standard-carriers.shtml

I think you've got it nailed. If one side is dragging, that's exactly what will happen. With an open diff that is.

Brian
[/quote]

I just checked out how stuff works.com and I fully understnd now. Damn now I want a locker ;D Just more money to spend :- Thanks again!
 

wolfman

Sr. Member
Joined
Jun 18, 2001
Messages
426
Loc.
Chesterton, Indiana
:eek: Before you buy a front locker , better check out the back. How do you know if the rear has a locker or not?
Take a hunk of chalk mark a line across the width of both rear tires on top of the tires, put the transfer case in netural use a floor jack to raise both rear tires off the ground at once. On the drivers side turn the tire clockwise 1/4 turn, if the chalk line on the passenger side tire is pointing to the front bumper you have an open rear end, if the chalk line is pointing to the rear bumper you have a locker of some sorts in the rear.
my opinion only
 
Top