• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Power steering bleeding

zoob

Sr. Member
Joined
Nov 24, 2010
Messages
388
Loc.
Long Island, NY
I just installed a single port canned ham Saginaw pump no hydro, what's the best way to bleed the system? Thanks!!!!
 

BUCKNBRONK

Sr. Member
Joined
Jun 30, 2011
Messages
521
Loc.
fresno
The ps box should still be full of oil, just fill the can and let the oil settle in the lines.

You can do this if you want or if air gets in the system, this is more for a ps box replacement IMHO.

jack up the front end. top off the can with ps oil. with motor off turn the wheel lock to lock 25 times. meanwhile check and keep the can to the full mark with ps oil. fire it up, check the oil level, turn wheel lock to lock 25 times. (you might have to start & stop the motor a few time to get the right level) check the ps oil level. If u have air bubbles in the can keep cranking the wheel back and forth lock to lock. That should do it.

Note this is for a front end that is set up correctly. If cant get the air bubbles to stop, or if you are not sure the box is being turned lock to lock , pull the pitman arm off the ps box and do as above. Reinstall pitman in same location as it came off.- hope this helps
 

tankhunter

Jr. Member
Joined
Aug 10, 2009
Messages
142
if you got a vacuum brake bleeder take an old power steering cap and drill hole in for an 1/8 mpt X 1/8 barb fitting hook that up to your brake bleeder get the front tires off the ground turn the brake bleeder on start the engine you will only need to got lock to lock 1 time and you will be done
 

glass 73

New Member
Joined
Sep 13, 2011
Messages
24
i have my front end apart for disc brakes and new linkadge for steering, put on used power steering pump and figured why not try bleeding with all apart and off ground, when turning wheel all the way to stop to stop fluid is squirting out of filler tube,but when running before going lock to lock was normal,is this from over travell of the box with nothing to stop it early .or do i have another problem. thanks
 

Chief Master Sergeant

Retired U.S. Air Force
Joined
Nov 6, 2002
Messages
5,222
Following everyones advice, I removed the pitman arm (I was told this is better that simply jacking the front up), removed the PS pump cap, and slowly turned the wheel lock to lock 40 times, without actually hitting the locks. This was with the engine off. Then I removed the coil and turned the engine over for 10 seconds, checked the fluid, and turned the wheel from lock to lock 10 times. Repeat. Then I replaced the coil wire, and fired it up. Continued to turn the wheel from lock to lock about 20 times. I turned it off, refilled the fluid, and replaced the cap. Problem solved.

I also added a cooler, which probably helped as well.
 
Top