chris-nc
Bronco Apprentice
- Joined
- Sep 1, 2020
- Messages
- 52
I'm working to sort out everything after completely gutting the cab and rebuilding everything, including the 3-speed manual steering column. I've installed new thrust washers and the thick spacer between the shift levers. Unfortunately, I didn't turn that thick center spacer 90* like I'm now reading that I should have. My questions:
- can I turn that spacer to the correct orientation without pulling the entire column apart again?
- if so, is there a certain gear that it should be in to allow it to turn?
I've pulled the steering wheel, and relieved the tension on the bearings, and it still won't turn. I have a feeling I need to pull the actual shift lever shaft out in order to correct this, which I'm really hoping not to have to do.
Chris
- can I turn that spacer to the correct orientation without pulling the entire column apart again?
- if so, is there a certain gear that it should be in to allow it to turn?
I've pulled the steering wheel, and relieved the tension on the bearings, and it still won't turn. I have a feeling I need to pull the actual shift lever shaft out in order to correct this, which I'm really hoping not to have to do.
Chris











