• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Rear leaf spring question

rednck21

Bronco Guru
Joined
Feb 27, 2002
Messages
3,915
Can anyone tell me exactly why the double wrap eye goes on the front hanger? I installed one backwards awhile back and they seemed to fit just fine...
 

pcf_mark

Bronco Guru
Joined
Jun 11, 2010
Messages
3,697
The front eye takes drive torque / wheel hop and twist during wheel travel (the wheels do NOT go straight up and down they actually go up and forward).
 

SHX669

Bronco Guru
Joined
Jan 9, 2009
Messages
1,997
Dont know if all springs are made like mine but the "centering pin" hole in my springs are not centered in the spring lengthwise. If mine were installed backwards it would shift the axle .
 

bronconut73

Bronco Guru
Joined
Aug 7, 2012
Messages
9,919
The double wrap is a safety device.
If your break a main leaf the other is there to keep the spring from dropping out of the hanger.

You really should put them in the right way.
Not too bad, just a heavy and clunky job.
 
OP
OP
rednck21

rednck21

Bronco Guru
Joined
Feb 27, 2002
Messages
3,915
Dont know if all springs are made like mine but the "centering pin" hole in my springs are not centered in the spring lengthwise. If mine were installed backwards it would shift the axle .



That's exactly why I was asking. My center pin is about 1/2"-5/8" off. By flipping them, I would get that extra clearance for the wheel wells on a LUBR without having to re weld the offset perches. Since my rig is a street truck I have to wonder what the chances are of actually breaking a leaf...?
 

pcf_mark

Bronco Guru
Joined
Jun 11, 2010
Messages
3,697
I broke a leaf on a stock 6 cylinder 68 Mustang. I had some wheel hop (it was wet!) and bang it broke!
 
Top