• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

rear spring perch placement question

bushman_22

Jr. Member
Joined
Jul 22, 2010
Messages
132
Loc.
Aloha, OR
I am installing full width axles in my 72. This is the one that was converted to front leaf springs back in the 70's. I don't know how many other things were modified back then. So my question is the best way to figure out spring perch side to side placement. I don't trust the original axle perch placement. Does anyone have measurements that I can use. Maybe off of a pumpkin stud or end of axle housing?

Thanks,
Bushman
 

broncodriver99

Bronco Guru
Joined
Jan 27, 2008
Messages
4,780
Loc.
Glen Allen, VA
Are you redoing the front and staying with leafs?

Assuming the axle is removed. I would make sure all bushing are in good shape and all bolts are tight. Measure from center pin to center pin on the springs, then measure from wheel mounting surface to wheel mounting surface on the axle. Subtract the center pin measurement from the wheel mounting surface measurement. Divide that number by two. That is how far in from the wheel mounting surface the center pin hole in the perch should be on each side. That would give you a perfectly centered axle.
 
OP
OP
B

bushman_22

Jr. Member
Joined
Jul 22, 2010
Messages
132
Loc.
Aloha, OR
That wasn't going to work. I ended up measuring axle housing (inside of flange to flange 59.75 ) and subtracted pin to pin (36")=23.75 Divided in half =11.875 Then subtracted 1.25 additional (half of spring perch width)
That left me with 10.75" outside of perch to inside of flange. Does that sound about right?

Bushman
 
Top