• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Rebuilding a steering box

kaw550

Bronco Guru
Joined
Jul 4, 2007
Messages
1,136
I was searching through the rebuild post and I am interested in trying it out but have a few questions.

What is the best source for a rebuild kit?
Is there a chain store kit that is complete?

How does changing the gaskets, seals and bearing remove the play? Wouldn't the play be cause by a worn worm gear? Mine doesn not leak but it does have a small amount of play in it.

I was going to send it out but It looks looks like the kits will cost about the same as shipping the box one way.
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
Try Napa for the kit. The worm gear does wear but there are also some adjustments you will need to make during the rebuild that may help take some play out of it. One thing in particular to look at is the torsion bar pin the the input shaft. The pin in mine was very loose and worn causing a lot of slop in the wheel.
 

tasker

Contributor
all knowing of nothing
Joined
Jun 2, 2006
Messages
21,707
Loc.
NH
can probably get you a Ford kit, feel free to give me a ring
 

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
If its not leaking dont bother with it. While it is possible to adjust it a bit if the worn and rollers are worn it wont help. all you will end up doing is jaming te sector shaft into the piston and cuase a hard spot in the steering and probably accelerate wear. To remove the play your best bet is to send it out they will rebuilt it correctly as they will have the correct sized parts to rebuild it with. If you want to reseal it then the local parts store will have what you need.
 
Top