• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Roll cage install questions ?

gregg142

New Member
Joined
May 21, 2008
Messages
8
Loc.
Mercer, PA
Restoring a '69 Bronco. Bought a 8 point family cage to install. Looking for suggestions (do's and don'ts) with install. Also looking for ideas on how to tie into body. Not going to be used as a racer or much climbing. Bolt thru floor good enough ?? Thanks.
 

Pedestrian

Bronco Missionary
Joined
Sep 10, 2008
Messages
2,299
Bolt thru floor with backing plates should work just fine for your needs.
 

jlong1974

New Member
Joined
Jun 30, 2004
Messages
36
Just make sure to build the backing plates slightly bigger or smaller than the cage foot pads in order to avoid "scissoring" of the floor sheet metal.
 

Dan's73

Bronco Guru
Joined
Oct 17, 2006
Messages
1,117
If the floorboards are solid, as mentioned, you should be OK with good floor & backing plates. My '73 has zero rust and, for now anyway, my cage is simply mounted to the body. Regardless of planned use, rollover protection is always a good idea. It's not the offroading that I was worried about when I put my cage in, it was the idiot drivers on the roads that are totally unpredictable....

As for installation advice: take all of the interior out, place (or tack-build) the cage in the EB, then place all of the interior pieces back in there. You don't necessarily need to bolt everything down, but you will want to make sure everything fits and is placed where you want it. Once you're satisfied with how everything fits, take it all back out to weld and/or paint the cage outside of the EB. In my experience, it's much easier to work around a cage when it's out of the vehicle. It's also helpful to take a few measurements before you pull the cage for final welding and check them frequently to make sure things aren't pulling together or getting tweaked as you weld.

Having at least 1 extra set of hands to help is almost required. I'm fairly strong & did a standard 6-point cage myself: only 1 scratch & 1 dent on the EB. When I went to the family cage I had 2 guys help & it went much smoother.
 
OP
OP
G

gregg142

New Member
Joined
May 21, 2008
Messages
8
Loc.
Mercer, PA
Thanks I appreciate the advice. Can't wait to get it on the road. Been working on and off on it for a year and half. Starting to go back together and it's getting exciting. My first EB restore. Quit racing and had to get dirty on the weekends somehow !!!!!!!!!!
 
Top