• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Swap '76 Third Member into '73?

no_gamecocks

New Member
Joined
Sep 22, 2003
Messages
19
Loc.
Northern Virginia
I've got a 76 parts truck that has a 4.10s whereas my working 73 has 3.50s in it. I was thinking I could swap the third member into my 73 so I'd only have to have the front axle setup professionally cutting my cost in half. Is there anything wrong with this idea? I've never dropped a third member so I'm not sure what's involved other than the obvious disconnecting the DS, sliding the axles out, etc.
 
OP
OP
no_gamecocks

no_gamecocks

New Member
Joined
Sep 22, 2003
Messages
19
Loc.
Northern Virginia
Well I'm 3.50/3.50 of course in the 73. I'd have to have a pro install the matching ring and pinion in the 44 up front. I was just trying to reduce the cost since I have the 76 for parts anyway. Mainly I can't justify spending 1000-1200 bucks to go from 3.50 to 4.10 if I'm still using the 28 spline rear and no "real" lockers. At some point if I start wheeling this more I'll have to plunk down some real cash for better shafts, a Detroit, etc. For now I just want a little more pep. It's got 32" tires w/ a C4 and very mild 302. Not enough oomph.
 

stlkikn

Sr. Member
Joined
Sep 14, 2005
Messages
402
So far 73 stallion has the best idea. The 76 should have the HD 9" housing in it, it will have larger brakes too if it does.
And the front has discs as well. If you have all the pieces from the parts truck, swap it all in.
 
OP
OP
no_gamecocks

no_gamecocks

New Member
Joined
Sep 22, 2003
Messages
19
Loc.
Northern Virginia
I've also considered swapping the whole axle. My 73 is also a "big bearing" for whatever that's worth. You think the 76 nine each offers some significant advantage in brakes? The only reason I'm hesitant to swap the whole axle is that the parts truck is in my back driveway (not in some field or something) and I'd probably end up cutting off the U-bolts and I'm afraid I'd wind up with an immovable truck on blocks in my driveway. Or best case, I could buy some new hardware but then I'd still have to reinstall the 73 axle on the 76 and it would add cost and time to the project. Probably not worth it. As for swapping the 44, I already did a cheby disc conversion on mine and I prefer the old style steering setup to the 76-77 style
 

stlkikn

Sr. Member
Joined
Sep 14, 2005
Messages
402
Its not only the big bearings, but the housing is actually larger/ stronger around the centre section. I agree with you about the steering on the pre 75 diff, thats why my 69 w/77 diffs has 75 style steering... so yeah, the front wouldn't be an improvement.
 

House

Contributor
Minutia Militia
Joined
Aug 12, 2004
Messages
2,440
Even though there are different sizes of axles for the different housings, bearings, brakes, etc. all 66-77 third members are the same, correct???
 
Top