• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

1978 Bronco Explorer Swap P heads

MonsterBIlly

Sr. Member
Joined
Dec 17, 2015
Messages
461
I am doing a explorer swap into a 1978 bronco. I am looking for the best set of headers. I do have the P heads. it seems as though the 1993 mustang headers will work. I am fine running a long tube but prefer the Shorties.
I have looked at Bronco hut and BC broncos. I know there are only a few choices on an early bronco but I would assume more on a 78 since there is more room. Does anyone here have experience.

BTW, I did a search and read several threads I just am wanting to get a little more specific if I can.

Thanks
B
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
But there’s still a lot of stuff where you don’t want it. Even on the big trucks.
The factory Explorer manifolds, or Shorties (in the case of the tubular ones) would fit the head at least, but only half sure that they would clear all the interior fenders and frame members before heading out the back.
I would seriously look at Sanderson, in case they have a P head variety. They build headers for both the full-size trucks and the P heads for Broncos, so may have some insight.

Since the Windsor family of engines was never available from the factory in the four-wheel-drive truck, there won’t be any off-the-shelf headers specifically for that. And if there were they’d for sure, be expensive!
But they were available in the 2 Wheel Dr., and even though the frame was different, the body should be the same, and that might be your best bet.
Get a set of long or short tube headers for an F series with a 302 or 351, then just dent the head pipe a little bit around the spark plugs to make them fit.
I think it’s only one Header on one side, maybe?
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,110
I wonder if you can notch the K-code manifolds like you can the stock Bronco manifolds to clear the P-heads?
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
I've actually thought about that!
If I ever build my standard head '71, I want to use the K-code manifolds. But I've got headers too (multiple types!) so the dilemma builds.
I'd better get on it!

But back to your thought, I'd only wonder if there is enough material to take out. Or if it's even needed.
Do you have a good close-up of your installed manifolds? Maybe someone familiar with how much tweaking you have to do to a tubular header could add their two cents.

Paul
 
Top