SOLD The Cure! Drag Link To Tie Rod End Bushing...

[TheGanzman]

P/N#R1768 - This is Ruff Stuff Specialties' bushing for the 1 ton GM TRE:
http://www.ruffstuffspecialties.com/catalog/R1768.html

I purchased this incorrectly for my newly-replaced WH suspension; paid ~$29.00 shipped, installed it, greased it, drove it around the block, realized that the hole was too big, and ordered the correct P/N#R2008, which BTW I had to drill out to 11/16"+ to fit. Ruff Stuff would not accept this for exchange, BTW...

$20.00 shipped CONUS - PayPal is fine.

 

[jrcflash]

I will take it. Sending PM....

 

[TheGanzman]

I will take it. Sending PM....

On Hold for you, but still haven't rec'd PM. You can email me at ganzman (insert at sign here) cox (dot) net

 

[canzelc]

P/N#R1768 - This is Ruff Stuff Specialties' bushing for the 1 ton GM TRE:
http://www.ruffstuffspecialties.com/catalog/R1768.html

I purchased this incorrectly for my newly-replaced WH suspension; paid ~$29.00 shipped, installed it, greased it, drove it around the block, realized that the hole was too big, and ordered the correct P/N#R2008, which BTW I had to drill out to 11/16"+ to fit. Ruff Stuff would not accept this for exchange, BTW...

$20.00 shipped CONUS - PayPal is fine.

Sorry to hijack, but how did the R2008 work, did it stop or reduce the tie rod roll? I am interested in purchasing one.

 

[TheGanzman]

Sorry to hijack, but how did the R2008 work, did it stop or reduce the tie rod roll? I am interested in purchasing one.

Hard to say, since I did the entire F&R suspensions/steering all at the same time - plus I put a LOT of caster in it. Sure didn't HURT it none; not too hard to figger that a fairly "solid" mount at that location HAS to be better than a big rubber "donut", IMHO...

 

[TheGanzman]

SOLD to the man with the funny hat! Thanks, jrcflash!