I got the steering box moved forward a few inches. I will be able to finish it up when the Bronco is on the ground. The bumper is in the way and can't remove it because it is sitting on the stands I built. 1/4" plate on both sides with DOM sleeves between the frame.
To get the 5.5" up-travel I wanted, I needed to roll the upper link mount to the rear a few degrees so it didn't contact the motor mount.
I was able to get my trac bar and drag link perfectly aligned and within an inch or two of being the same length. I'm hoping I won't have any bump steer with this setup.
Full bump looks good. I could move my axle forward another inch if I wanted to, but I would have to get creative with the upper link mount.
My upper link mount was hitting my starter before I achieved full bump so I put a 15* bend in it. 1.75" DOM with a 1.5" DOM internal sleeve that runs almost the full lenght. I left the inner a little short so my tube inserts would fit.