• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

=trans swap NP435 to T19

Pa PITT

Contributor
Bronco Guru
Joined
Jul 15, 2005
Messages
11,300
Loc.
Stephenville TEXAS
ok so what besides a clutch would my Running Buddy need If he was to remove his NP435 & Put in a T18 or T19.
His NP435 may have issues ... & I have EITHER THE T18 or T19.
I THOUGHT TODAY. I could give him my trans & instead of fixing his .. He might could gain an OD..
i DON'T RECALL WHICH my trans is ..
But I think one has a normal 1st gear & 4this OD.
& OTHER HAS A LOWER 1ST GEAR THAT IS SYNCHRONIZED IN 1ST GEAR BUT A ONE TO ONE 4 th GEAR..
... SO WHAT WOULD IT TAKE TO SWAP THE TRANS .
 
OP
OP
Pa PITT

Pa PITT

Contributor
Bronco Guru
Joined
Jul 15, 2005
Messages
11,300
Loc.
Stephenville TEXAS
well after some more Googling last post i FOUND SAID NEITHER TRAN HAD THE O/D.
i THOUGHT ONE OF THEM DID .
aFTER READING ABOUT 18 & 19'S IT didn't sound like we want either .
They said the gear splits were terrible in both 18 & 19's.
 

Yeller

Contributor
Bronco Guru
Joined
Mar 27, 2012
Messages
7,692
Loc.
Rogers County Oklahoma
I'd fix the 435, it fits already. no advantage to the 18 or 19. If they are both wide ratio units (most were) the splits are about the same as the 435 so its a fair amount of work with no gain. There was a few close ratio 19's, made a nice driving transmission but were still clunky shifting like a truck trans.
 

bmc69

Contributor
Bronco Guru
Joined
Jun 11, 2004
Messages
12,015
T-18 is so close to the NP-435 that it explains why Ford delivered them interchangeably in 70s trucks. The T-19 is basically just a T-18 with a synchronized first gear.
 

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
should be pretty straight forward swap use adapter off the NP the 1 in length difference shouldn't be a issue unless your lifted then you may want to verify front driveshaft length. May have to cut the tunnel a little larger if it is close on the NP currently there but otherwise it all will work. while not a huge difference I like the NP's slightly lower gearing vs the t18
 
Top