Hey Everyone,
I am replacing my old transmission cooling lines with a new set from JBG. The ones I had were hacked up with pieces of rubber hoses going to the radiator. My question:
How do the stock steel lines route? At what point do they go above the frame? Is it possible to install these with the engine in and intact or do I need to remove the alt and right exhaust header? Or heaven forbid, the engine:-[
TIA,
Jim
I am replacing my old transmission cooling lines with a new set from JBG. The ones I had were hacked up with pieces of rubber hoses going to the radiator. My question:
How do the stock steel lines route? At what point do they go above the frame? Is it possible to install these with the engine in and intact or do I need to remove the alt and right exhaust header? Or heaven forbid, the engine:-[
TIA,
Jim











