• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Transmission line routing

BroncoJimbo

Contributor
Long-term owner
Joined
Jun 11, 2014
Messages
291
Loc.
North GA
Hey Everyone,
I am replacing my old transmission cooling lines with a new set from JBG. The ones I had were hacked up with pieces of rubber hoses going to the radiator. My question:
How do the stock steel lines route? At what point do they go above the frame? Is it possible to install these with the engine in and intact or do I need to remove the alt and right exhaust header? Or heaven forbid, the engine:-[

TIA,
Jim
 

savage

Bronco Nut
Joined
Apr 18, 2007
Messages
2,483
Loc.
Renton
I'm assuming its a c-4? If so this is my new line installed with engine in, and everything else on, it can be a pain, but it can be done.
 

Attachments

  • trans bolt and lines 005.jpg
    trans bolt and lines 005.jpg
    94.5 KB · Views: 421
  • trans bolt and lines 004.jpg
    trans bolt and lines 004.jpg
    72.3 KB · Views: 328
  • trans bolt and lines 003.jpg
    trans bolt and lines 003.jpg
    71.8 KB · Views: 364

idus25

Contributor
Full Member
Joined
Oct 30, 2014
Messages
213
Loc.
St. Louis
You will more than likely need to drain the radiator, not sure what will drain out of tranny if anything. The lines can be replaced with engine, headers, etc.. still in place. They come above the frame just before the front crossmember, and come under the motor mount. See pic. This is a '76.

20150109_114241_resized_zpsc71160d2.jpg
 
OP
OP
BroncoJimbo

BroncoJimbo

Contributor
Long-term owner
Joined
Jun 11, 2014
Messages
291
Loc.
North GA
Thanks Guys!
I removed the alternator and once I did that I could see how the routing should go. One thing however, do the lines go above or underneath the tranny dipstick/fill tube? I am thinking they should go above which means I'll need to remove the pan. If I do that I might as well upgrade the pan to the B&M cast unit from JBG. It's been leaking for years.
 

savage

Bronco Nut
Joined
Apr 18, 2007
Messages
2,483
Loc.
Renton
Here are some more photo's, how it hook's up to the rad and trans. I had to un screw my dip stick on the trans to get them to go between.
 

Attachments

  • DSCN0028.jpg
    DSCN0028.jpg
    103.3 KB · Views: 326
  • DSCN0022.jpg
    DSCN0022.jpg
    94.5 KB · Views: 425
  • DSCN0018.jpg
    DSCN0018.jpg
    66 KB · Views: 325
OP
OP
BroncoJimbo

BroncoJimbo

Contributor
Long-term owner
Joined
Jun 11, 2014
Messages
291
Loc.
North GA
Thanks Savage, I thought as much and you confirmed it for me. I went ahead and ordered the new pan from JBG. The original pan is pretty beat up and has always leaked. Since this whole thing started with reducing the oil spots on my garage floor I figured I might as well go whole hog!
Thanks,
Jim
 
Top