• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Turnsignal/column wire disconnect

newsome311

New Member
Joined
Mar 8, 2021
Messages
13
I am having trouble disconnecting the turnsignal/column wires from the horseshoe shape clip under the dash. Are there any tricks. I believe that everything I have is original. I have seen videos after the horseshoe has been separated, then you pull the red divider out and use a small flat head to get the pins out, but I can't even get to that part %). I don't want to break the clip, but is it just simply pull really hard?

Thanks
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
Hey newsome. Welcome to classicbroncos!
Is yours a '76 or '77 then? Or an earlier model?

I had more to say, but when I tried I got the same "error" message I've been getting a lot lately.
Maybe I've just said too much and used too many words and the website is tired of it!

Paul
 
OP
OP
N

newsome311

New Member
Joined
Mar 8, 2021
Messages
13
Well I got it.

Thanks for the replies.

I have a '76. I did finally get the horseshoe to unplug. I have an original steering column and that clip just didn't want to come out. I slipped a flat head on one side of the clip and just used a bunch of pressure to push it out. It worked and didn't break anything ;). Thanks
 

FordBronc

Contributor
Bronco's, yea I have a couple.
Joined
Dec 26, 2010
Messages
1,518
Loc.
Polk County, Missouri
There should be a locking clip you need to lift up a bit. Then use a small flat tip and pry a little on each side and work it apart. As far as the wires, maybe this will help?
 

Attachments

  • ts00.jpg
    ts00.jpg
    12.4 KB · Views: 62
Top