SnwMnkys
Sr. Member
I just finished an EFI swap on my 351w and am trying to fine tune some things. I pulled a vacuum reading and im getting a fluctuation in the needle of about 14.5 to 16. Its a real slow and steady movement, but no pattern in the movement, meaning it will go from 16 to 15 to 15.5 to 14.5 back to 16. Just completely random. Can this be a vacuum leak? Would a bigger cam cause this?
Ive got an FMS cam with 214/224 duration .472/.496 lift, and 112 lobe separation. Nothing aggressive but bigger than stock.
Oh and my vacuum readings probably appear low, but im at 4500ft above sea level, so 15-16 is about normal for me.
I also was pulling my vacuum reading from the port that my FPR hooks up to, i just disconnected the FPR and connected the gauge. Not sure if I should try to hook up the vacuum gauge to its own port and leave the FPR connected or not.
Ive got an FMS cam with 214/224 duration .472/.496 lift, and 112 lobe separation. Nothing aggressive but bigger than stock.
Oh and my vacuum readings probably appear low, but im at 4500ft above sea level, so 15-16 is about normal for me.
I also was pulling my vacuum reading from the port that my FPR hooks up to, i just disconnected the FPR and connected the gauge. Not sure if I should try to hook up the vacuum gauge to its own port and leave the FPR connected or not.











