• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

warn lockout hub installation - New pics added

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,651
What JohnJohn said. The plastic/nylon (or bronze original) is a thrust washer and is what keeps the wrong things from touching each other when the axle shaft is thrust outward towards the spindle.

It's obvious whch way it goes (like you have it) when you try to run it up the axle shaft. The bevel fits over the fillet/radius of the outer shaft.

Paul
 
OP
OP
B

Brewmover

Full Member
Joined
Jul 6, 2014
Messages
159
Loc.
Tulsa
IT IS ON!!!!! You guys kick ass! Thank you all for your feed back. The culprit....a spindle bearings where not fully seated. Nice eye DirtDonk!
 

JohnJohn

Contributor
Bronco Guru
Joined
May 6, 2005
Messages
2,179
Loc.
Richmond
Congratulations!
Same thing happened to me with that small seal and the bearing
 

Steve83

Bronco Guru
Joined
Jul 16, 2003
Messages
9,360
Loc.
Memphis, TN, USA, Earth, Milky Way
Could it be that the Warn requires the adjusting nut to be set deeper than the stock part?
It has nothing to do with wheel bearing nuts.
...damage that could be equated to be from the missing snap ring.
Unless some of the many busted up Warn hubs were due to this...
The damage that would result would be knuckle U-joints grenading.

..I don't know if this is a critical measurement or not, and it's not likely to fix your issue with the snap ring (though it could...
It can be from the spindle bearing installation depth (if it was replaced). It can be from the spindle bearing seal & shims being installed incorrectly.

But I think it's mostly from the hub locks NOT being aligned properly to their own internal splines. Try turning EITHER the hub or the axleshaft while pushing the lock ring into the lock body so the hub locks to the axle. Release the lock ring, then try installing the snap ring to the axle shaft.






...oh, well. Congratulations. Remember next time that pics get results quick. ;)
 
Top