horhay25
Full Member
About to get my engine wiring squared away, but there is one remaining question I have...
I have a Sniper EFI w/coil driver module (took the place of my MSD 6al) and a MSD blaster 2 coil..
In the painless directions it says I'm to wire Red/Green #920 to the supplied ballast resistor to Coil +...HOWEVER..if using an internally resisted coil or MSD Ignition Box the resistor will be omitted. If the Sniper coil driver module took the place of the MSD ignition box, would that coil driver handle resistance and I can omit the Ballast resistor??
For anyone running this same setup..did you use or not use the ballast resistor??
PS..I've tried Holley Tech Support several times in the last few days and hold times are over an hour with no chance for a call back..
I have a Sniper EFI w/coil driver module (took the place of my MSD 6al) and a MSD blaster 2 coil..
In the painless directions it says I'm to wire Red/Green #920 to the supplied ballast resistor to Coil +...HOWEVER..if using an internally resisted coil or MSD Ignition Box the resistor will be omitted. If the Sniper coil driver module took the place of the MSD ignition box, would that coil driver handle resistance and I can omit the Ballast resistor??
For anyone running this same setup..did you use or not use the ballast resistor??
PS..I've tried Holley Tech Support several times in the last few days and hold times are over an hour with no chance for a call back..