fromme
Full Member
I got around to finishing the wiring on my Centech harness to the brake warn light. Connected the prop valve and the warning light and the ignition switch. Problem is that the warning light does not come on during crank like it should. I have done some trouble shooting and found that there is power to it, the bulb is good, and if I jump the connector at the prop valve to ground the warning light does come on like it is supposed to. So I know I have it wired correctly and the power and grounding is there.
Any ideas as to why the ignition switch isn't grounding the light like it's supposed to during crank? It is a brand new switch assembly that I got from Toms. So I figure it should be good. What's the chance I got a bad one out of the box? I looked through the factory service manual and it shows the switch body is grounded to the dash so I wonder if maybe there isn't good contact there. I don't exactly know how that ignition switch connects a ground during crank. Any ideas?
Any ideas as to why the ignition switch isn't grounding the light like it's supposed to during crank? It is a brand new switch assembly that I got from Toms. So I figure it should be good. What's the chance I got a bad one out of the box? I looked through the factory service manual and it shows the switch body is grounded to the dash so I wonder if maybe there isn't good contact there. I don't exactly know how that ignition switch connects a ground during crank. Any ideas?











