hammer
Bronco Guru
- Joined
- Nov 13, 2006
- Messages
- 1,359
Hey Guys,
I'm installing the 1/8" skis. The issue I have is with the three stainless screws that hold the ski to the rocker in the middle. I started the first side and two went in okay but the third isn't holding and just spinning. I suppose I could go get bigger screws and try again but I was thinking of taking a hole saw, cutting three holes on the back side of the rocker so i could get a socket in there and then bolting them up. Then I'd cover the holes on the backside with some rubber grommets. What do you think of this? Not crazy about cutting unnecessary holes in my tub as I spent a year making it perfect but I see it as my best option. I aslo see getting a nut in there a huge PITA. I've never used rivnuts before, not sure if that's and option as well.
I'm installing the 1/8" skis. The issue I have is with the three stainless screws that hold the ski to the rocker in the middle. I started the first side and two went in okay but the third isn't holding and just spinning. I suppose I could go get bigger screws and try again but I was thinking of taking a hole saw, cutting three holes on the back side of the rocker so i could get a socket in there and then bolting them up. Then I'd cover the holes on the backside with some rubber grommets. What do you think of this? Not crazy about cutting unnecessary holes in my tub as I spent a year making it perfect but I see it as my best option. I aslo see getting a nut in there a huge PITA. I've never used rivnuts before, not sure if that's and option as well.











