• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Mass Air Sensor

SWFLABRONCO

Sr. Member
Joined
May 12, 2006
Messages
621
Loc.
Cape Coral, Fl
After trying unsuccesfully to get the engine to idle properly I discovered that unplugging the mass air sensor and letting the ECM switch back to the default setting, the truck actually idled correctly (almost). I could put it in gear and the engine would idle back up where it wouldn't before with the sensor plugged in. I'm running 24lb injectors and a sensor (bought off ebay) that is supposedly calibrated for that size injector. Without spending $200 on a new sensor, or the same amount or more to send mine back to the manufacturer for inspection, are there other options out there or anyone with suggestions? I'm not sure what I have is shot, I just know it doesn't run with it plugged in.
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,112
That sounds completely like a bad MAF to me.
The only other thing that is simple is...
Do you have the direction of airflow correct? MAF will send very bad signals if flowing backwards.
 
OP
OP
SWFLABRONCO

SWFLABRONCO

Sr. Member
Joined
May 12, 2006
Messages
621
Loc.
Cape Coral, Fl
I haven't pulled the codes, and honsetly this being my first EFI attempt, not quite sure what I'd need to do it. As far as TPS voltage goes, we didn't get that far since it seemed so obvious that the mass air was the culprit. The direction of the meter seems right but for the heck of it I may turn it around to see if it changes the results. Can't make it run worse than it already does.
 

ransil

Bronco Guru
Joined
Sep 6, 2003
Messages
8,138
Stock mass flow sensors have an arrow on them for air flow.
Did you follow the idle set procedure either in any EFI repair manual or from the many post on CB.com or over at SBFtech??
Do that first then.
Then check for vacuum leaks.
Do you have the PCV setup properly?? ( closed system..)
 
OP
OP
SWFLABRONCO

SWFLABRONCO

Sr. Member
Joined
May 12, 2006
Messages
621
Loc.
Cape Coral, Fl
The sensor is an aftermarket (Pro M) unit that is not marked for flow but seems to only be able to go 1 way. We've gotton all of the vacuum leaks plugged but we didn't follow a particular procedure for idle setup.
 

70_Steve

Old Guy
Joined
Dec 13, 2002
Messages
8,317
I haven't pulled the codes, and honsetly this being my first EFI attempt, not quite sure what I'd need to do it.
I used a $5 test light from Autozone. Here's the procedure, from FordFuelInjection.com
http://fordfuelinjection.com/?p=13

For the idle reset procedure, you can search the web using Google, or search this site for posts by ransil, probably looking for "idle reset".
 
Top