The stock vent is press fit, and can be stuborn when you try to remove it. If I remember, the hole is already just about the right size for a 1/4" NPT tap. X2 on the 90° fitting.It doesn't really matter. Remove it (whatever it takes), drill it for the tap, tap it for the fitting, screw the fitting in (I highly recommend a 90° elbow), and run the hose wherever you like.
Don't T hoses together from components that use different fluids (T-case gear oil X ATF).
Always a good idea to protect yourself from certain fluid exchanges!!!Guess there could be some fluid exchange on inclines.
Grease on the tap works.Thanks, getting ready to put the D20 back in but better try this first. Already have the tail housing installed on the case. Need to find a way to keep shavings out of the case.
Mount the case in a vise so they fall away instead of in.Need to find a way to keep shavings out of the case.
Thanks, getting ready to put the D20 back in but better try this first. Already have the tail housing installed on the case. Need to find a way to keep shavings out of the case.
If you ever plan on driving through even relatively shallow water, you may want to extend the breathers on all gear cases (diffs, t-case, tranny) up higher to avoid the possibility of water getting into those area.whats wrong with the stock breather? why mod the breather? any pics or write ups on how to change the transfercase breather? i currently have the t-case out and would like to convert mine if it's better.
Virtually every fluid chamber on a vehicle has some type of vent, and that trans is no exception.Im also going to be installing an NP435. Is there a breather vent on that?
No. The NP435 vents around its shifter, so there is no fitting to remove/replace/modify/extend. The way Ford dealt with it was to put a LARGE closed-cell foam pad around the shifter tower that 'sealed' it to the body, and let it breath through the shifter boot.is it also the same process?
one last question, sorry to hi-jack.
I just got a tap and die set from harbor freight. As previously stated, i'll be using the 1/4 threader. The set i got came with 2 1/4. one is 1/4-20 and 1/4-28. Which one do i use? and what is the 20 and 28 mean?






