• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Play in diffs-normal?

mortimersnerd

Sr. Member
Joined
Aug 25, 2010
Messages
743
How much play is normal for a diff? I can move the driveshaft on both my diffs about 5-10 degrees of rotation. Figured this was normal and just play in the gears, axles, ARBs etc., but was curious to know if I was right.
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,112
5-10° is a good tight diff.
It is simply tolerance stack up. You need clearance between gears. not just the ring and pinion but the side gears and the spiders too. The axle splines into the side gears need clearance as well or you would never get them in. All the clearances inside the diff are multiplied by the ring and pinion ratio.

With low gears and a detroit locker I can get close to a quarter turn.
 
OP
OP
mortimersnerd

mortimersnerd

Sr. Member
Joined
Aug 25, 2010
Messages
743
OK, thought so since front and rear were similar. Just wanted to make sure as PO wheeled the truck pretty hard. Have some driveline vibes, but I think that has more to do with a slightly out of range u-joint (running about 10 degrees of angle, need to add some shims). Thanks for the help as always!
 

Zillacon

Sr. Member
Joined
Aug 10, 2007
Messages
848
Loc.
Hackin Away!
OK, thought so since front and rear were similar. Just wanted to make sure as PO wheeled the truck pretty hard. Have some driveline vibes, but I think that has more to do with a slightly out of range u-joint (running about 10 degrees of angle, need to add some shims). Thanks for the help as always!

I'll be setting up some more gears later this week or weekend if you want to come by and see it done first hand.
 
Top