How does the no-return work Is it a different fuel pump?
Keith, I'll have to double check when I get to work. But, I believe you'll have to go to '01 for a returnless 5.0L... If you look at your spare, even in the pic's, you can see the regulator on the rail and two lines connected to the rail. One feeds th rail, all injectors, then after the regulator, it returns to the tank. It wouldnt be as clean, but you can use that rail and plumb it like BB suggests. You'll just need to block the return line at the engine. The thing is, because the 5.8 is wider, the rail would have to be modified anyhow, so while modifying, you can simply eliminate the return hose, just make sure it doesnt leak!! At this point, I've still got the 5.0 sitting in mine and plan to just plumb it as a return system, because its how it was designed and the return rails are already there, easier to find a return 5.8 rail too.. May change my mind as time goes by, but thats where I'm at.
You will have to run a spacer under the upper intake for the Reg. to fit in the rear. And that will also require a body lift of at least 2". I like the cleaner look of a rear Reg.
The stroked 5.0 I put in the Ranger several years ago was done with a no-return fuel rail. the supply and return lines came up near the master cylinder. Regulator was placed near the drivers hood hinge. The supply from the pump fed into a "Tee" fitting. One leg went to the rail, the other to the regulator. The regulator manitained the pressure setting in the line and rail and sent the excess fuel back the return line. Vaccum line was only as long as needed to get to the regulator. Simple way to keep the regulator off the engine.
Would this work with an '89 MAF EFI system that originally had the regulator on the rail?
I like the idea of putting the regulator on the firewall and plumbing the return line from there.






