• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

What have you done to your Bronco today?

Fireball05

Bronco Guru
Joined
Oct 7, 2012
Messages
1,822
A wire wheel is going to take an awful long time. The paint stripper remover discs on a grinder will work pretty well for the flat portions. It's all the little grooves that run front to back in the back half of the cabin that's going to be a pain in the butt.
 

gnsteam

Contributor
Bronco Guru
Joined
Jan 29, 2010
Messages
4,148
Loc.
Lincoln NE
Topped off the oil again:p. About a half quart every two weeks. Next oil change, I'm going to make another attempt at the rear main seal.
 

asinor

Bronco Guru
Joined
May 13, 2011
Messages
1,396
Loc.
Tulsa, OK
What gauge do you want? If you don't want formed, Lowes and home depot have 16-20 gauge sheets that may be big enough.

Sent from my SGH-T989 using Tapatalk 2
 

jcpetrson

Sr. Member
Joined
Aug 26, 2012
Messages
435
What gauge do you want? If you don't want formed, Lowes and home depot have 16-20 gauge sheets that may be big enough.

I'm replacing part of the passenger floor pan so I'm looking for 16-18 gauge that is 16" x 20". I was able to find 1'x1' sheets of 16 gauge at HD. They had 20 gauge, but from what I've read here, it's too flimsy for floor pans. I'll check out Lowes.
 

Tedster100

Chairman of the Bored
Joined
Aug 25, 2010
Messages
1,762
Put the glass & new gaskets in my hard top. Tuned up a couple areas that showed up after priming it, re-primed and made a spreader to lift it for spraying the raptor liner. Hope to install the Raptor liner inside and out tomorrow.
 

ahansen_1985

Bronco Guru
Joined
Nov 2, 2008
Messages
1,245
Loc.
amity, oregon
Too dark for pics??? You know the order..Project-pictures-post.

http://www.youtube.com/watch?v=exsB9Pw36fQ


pasury2a.jpg
uje8yje5.jpg
8yzegese.jpg



1966,351w,m5od,205....3.5" lift, 2" body, 37/13/15 boggers
 

jcpetrson

Sr. Member
Joined
Aug 26, 2012
Messages
435
Filled another dozen holes. I think one of the POs got a drill one year for Christmas. Not too much welding left.
 

JSmall

Bronco Guru
Joined
Feb 18, 2004
Messages
3,224
Welded the steering cooler brackets to the new steering crossbar and painted it. Finished up the 4x4x2 swap so I'll be cleaning it up tomorrow and putting some paint on it. Should have everything installed tomorrow.
 

LOVNBRONCOS

Sr. Member
Joined
Mar 6, 2012
Messages
462
Loc.
Tucson, Az
Got Raptor Liner yesterday, Today was remove old insulation from under dash and fire wall, seats out, taped off some stuff and sanded front 1/4 of interior.
 
Top