• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Engine serial #

El Kabong

Contributor
Driving stuff Henry built
Joined
Oct 8, 2009
Messages
1,559
Can some decode this engine number for me?
EOAED3C15. I would like to know year and what it came out of.

I have been researching info on an unknown 351m/400. According to that research Ford used the first 4 positions for overall info. I would think that would apply to other blocks from similar years as well, but don't really know. The info below is what came from Google searches of "351m casting numbers", "351m casting number location", & "351m build date". You might try those terms following your engine description. The part number info came from here. This is what it said:

E=decade=80s (C=1960s, D=1970s, E=1980s)
0=year=0 (1980)
A=vehicle type=full sized car (A=full size car, T=truck, O=Torino, S=T-bird, & so on)
E=engineering group=engine (E=engine, W=axle, B=body, etc.)

Btw, between block, crank, & oil pan info, mine turned out to be a 400 from a 78 or 79 2wd truck. Cast on Dec 6, 1977 in the Cleveland foundry (It is not a Cleveland engine, but it was cast there). It would have been built sometime after that cast date. My build date appears to be hidden behind the timing cover, so it will have to wait till later to nail it down exactly. Cast date info from "How to Rebuild Your Ford V8, 351C-351M-400-429-460" by Tom Monroe. Foundry, cast date, & location info from here and here. I hope some of that helps in your hunt. Good luck.
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,114
The hard part about the casting numbers is they only change when a change is made. So from the above it looks like it is for an '80 car. But what the number really tells you is the last change to the block design was for an '80 car. Same block was used in cars and trucks and probably stayed the same up to '83 when the rear main seal changed.
 

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
X2 they only changed the casting codes when changes where needed so what ever they made the change of is the vehicle that got the casting number. But it could go into any model. To further complicate things all the drive accessories will also have casting codes for what they were designed for but can still go into different vehicles.
For basic engine parts you really dont need to know what vehicle it came out of just say its a 1980 302 out of whatever you like. Now things like belts may be more of a issue. it just depends on what pulleys it has.
 

Quick & Dirty

Sr. Member
Joined
Feb 15, 2004
Messages
857
Might want to check if it's a 255. They came out in '80, but I think they had E0SE casting code.
The intake ports are smaller than than the other small blocks, and oval shaped, might be able to tell from pulling the intake manifold, but I have no experience with them.
 

BRONCOBERT

Sr. Member
Joined
Sep 2, 2012
Messages
731
Did the Bronco 302 motors have the VIN stamped in them some place like the Chevy motors did?
 
Top