• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Will 87 speed density run a 351

AWS

Sr. Member
Joined
Aug 2, 2004
Messages
596
Loc.
ST LOUIS
I have all the new stuff for the 87 mustang speed density, just curious if it will run a stock 88 351 without a bunch of other mods.
Thanks
Steve
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
I think you would need a tune to get it programmed to run well. You could also convert it to mass air fairly easily.
 

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
Might get a EEC from a 5.8l truck that will run it. Of course you'll have to figure out if they are wired the same.
 
OP
OP
AWS

AWS

Sr. Member
Joined
Aug 2, 2004
Messages
596
Loc.
ST LOUIS
Might get a EEC from a 5.8l truck that will run it. Of course you'll have to figure out if they are wired the same.[/QUOTE]

I may check Ryan's website, it may have that answer buried somewhere in all those pages of stuff I never thought I would need!
 

baddad457

Sr. Member
Joined
Aug 24, 2011
Messages
560
The 87 351W's were SD setups. So yea, it should run it, although the truck EFI used an upper/lower that flowed more air.
 

73azbronco

Contributor
Bronco Guru
Joined
Nov 11, 2007
Messages
8,781
87 stang SD is made for a 302, not a 351. It won't work well unless tuned. Put it this way, it will be 302/351=about 14% lean at most settings.

That's the beauty of MAF systems, for the most part, they work on 302 to 351 with little issues. Yes, a tune is always advisable.
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
Might get a EEC from a 5.8l truck that will run it. Of course you'll have to figure out if they are wired the same.

The truck stuff was mostly batch-fire so the harness pinout is very different. Not worth the hassle to swap it.
 
OP
OP
AWS

AWS

Sr. Member
Joined
Aug 2, 2004
Messages
596
Loc.
ST LOUIS
So is there a easy wire/pin diagrahm for adding the mass air to my speed density harness. Then I'll just get the extra parts I need.
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
So is there a easy wire/pin diagrahm for adding the mass air to my speed density harness. Then I'll just get the extra parts I need.

Here's a good start.
 

Attachments

  • Speed Density to Mass Air Conversion.pdf
    26.4 KB · Views: 203
Top