stupidboy
My wifes porn star.
What makes a booster pull the brake pedal down as soon as the engine is started?
It doesn't pull the peddle down. It helps your foot push it down. If there is significant movement you may have air trapped in the system requiring bleeding to remove it.
I'll try to walk you through. The brake system is hydraulic, not vacuum. Air in the hydraulic brake fluid needs to be bled from the system. I can't dumb it down any further. I can suggest reading a basic auto mechanics book I'm sure they have pictures.
There is a direct mechanical linkage from the brake peddle to the master cylinder. The booster only assists the input effort made by the driver's foot. It doesn't pull the peddle. Air in the brake lines compresses so with the assist of the booster it compresses a lot more. Liquid doesn't compress so the peddle won't move farther when intake vacuum is introduced after the engine is started. With properly adjusted brakes the peddle movement likely is caused by air in the brake fluid. The op assumed the peddle movement is a result of the booster. The booster only magnifies the movement. I can't put the concept in simpler terms.
I start the engine without my foot on the brake and as soon as the engine builds vacuum the pedal automatically goes toward the floor boards and puts the brakes on. Can't even move the truck then. NO AIR in the brake system. The air theory in the hydraulic system would not do this without foot pressure to activate the the imbalance in the booster. Some how there is there is more pressure on one side of the diaphragm. But what could cause this????
While we are on this booster subject. What makes the brake pedal return to the proper position when the Bronco is cold, but once it's warmed up the pedal wants to only return 1/2 way back up. The brakes will have a slight drag and you have to pull the pedal back up with your foot.
Probably the same thing as above. Just not quite as worn out. Sticks open a bit when it gets warmer, or perhaps just after getting flexed a few times it just can't come back to neutral anymore because some material is just tired from old age.
Same question then. Is the booster original?
Have you looked for any mechanical interferences? Something falling in the way of the pedal pivot or pedal-to-booster rod?
Paul






