Rockstar Bronco
New Member
- Joined
- Nov 29, 2012
- Messages
- 14
I have a '72 Bronco (uncut) with an '88 5.0 block (rebuilt w forged pistons, fresh GT40P heads/intake, 70mm Mass Air Meter, BBK cold air intake, 70mm throttle body, long tube headers, and A9M computer). I have no idea what cam is in it and do not look forward to removing the serpentine setup to find out... though this is inevitable. Power transfers through an NV3550 5-speed (.78 OD) to a Ford BB 9" w 4.10 gears and 31" all-terrains. Total vehicle weight is <2500 lbs. (topless).
My goal is to make a torquey 300HP street driver that averages 20 mpg. Importantly, I'm at 5000' and drive from 0-12,000'.
1.) What cam would work best? I'm leaning towards E303. Is this a good choice for a daily driver that will likely never go North of 6000 rpm? I want it to hit hard right off idle and pull through midrange to WOT (doesn't everybody?). I'm aware that I need to beef up the valve springs in any event.
2.) I've read several threads in the Mustang forums discussing shorty headers for the P heads. Question: for my power goals and target rpm range, should I go shorties or long tube? If the latter, does anyone know of LT headers that will work with the P heads (in an Early Bronco)?
3.) A local guy can reflash the A9M to Cobra mapping. Assuming I would need 24# injectors and the right cam. Would this be overshooting my mark? Thinking I may be better off leaving the A9M alone and staying with the 19# injectors with the aforementioned intake components. Given my HP and MPG goals, what's the best way to go?
Any help/comments are greatly appreciated!
My goal is to make a torquey 300HP street driver that averages 20 mpg. Importantly, I'm at 5000' and drive from 0-12,000'.
1.) What cam would work best? I'm leaning towards E303. Is this a good choice for a daily driver that will likely never go North of 6000 rpm? I want it to hit hard right off idle and pull through midrange to WOT (doesn't everybody?). I'm aware that I need to beef up the valve springs in any event.
2.) I've read several threads in the Mustang forums discussing shorty headers for the P heads. Question: for my power goals and target rpm range, should I go shorties or long tube? If the latter, does anyone know of LT headers that will work with the P heads (in an Early Bronco)?
3.) A local guy can reflash the A9M to Cobra mapping. Assuming I would need 24# injectors and the right cam. Would this be overshooting my mark? Thinking I may be better off leaving the A9M alone and staying with the 19# injectors with the aforementioned intake components. Given my HP and MPG goals, what's the best way to go?
Any help/comments are greatly appreciated!











