...Those tires have been on it since before rebuild completion. Only thing different is change from manual box to power. Then that's when it got crazy...
Hmmm, I wonder if the steering box could be off-center? Did you verify that it was perfectly centered before putting the pitman arm on by any chance?
I know that's basic, but maybe it could have been moved off of center before you set things up and you didn't know it.
At this point, it's such a simple check, you might consider just doing it anyway.
...I also read when going to powersteering more caster is needed than manual.
Not necessarily "needed" so much as more caster is much more tolerable with power assist. The more positive caster, the harder it is to steer.
With manual steering and narrow tires and wheels, mine drove very well at only 1 degree or so of positive caster.
Now that I'm going power (finally!) I'm going to shoot for 4 to 6 degrees. But with my tire and wheel choices, I'm betting that 4 would be plenty for me.
I'm tring to make sure I rotate it enough and not to much. So I guess my question is would I rotate the Cs 8 degrees from where they sit now or point pinion toward case better then rotate needed degree from there... Which would be a few degrees more or does my cbushings take care of that?
Point the pinion first. That's why I mentioned going back to a 2 degree offset bushing, then getting all of your caster correction from the rotation of the yokes.
Leave the c bushing mounting pads where they are on the axle tubes as well. You're only concerned with the outer steering yokes, or "C's", to take care of caster.
So base it on your current settings, minus the 4.25° you lose when going to a smaller C-bushing, plus whatever you want from the rotation of the yokes.
In other words, you set your pinion angle with the bushings, and you set your caster with the yokes. That's all they're doing
But that's all just conjecture at the moment. Until you take a closer look at your pinion angle you won't know how much to change. I'm just guessing you'll want to go down to 2 degrees in the bushings, but you can verify that first.
One other thing I can think of that is effected by the c-bushings is the trackbar's lower mount. Whenever you pivot the axle housing, whether by lifting or lowering the suspension, or through c-bushing choice, you necessarily change the angle of the lower trackbar stud/bolt.
This can be a good thing, a bad thing, or neutral. Depends on how it aligns with your upper mount, or how your bar is set up. In your case, since you have a rod end at each end of the trackbar (is that correct?) then it may not matter.
But it's something else to take into account.
Paul