• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

c4 and the third gear

jeff_gates

Full Member
Joined
Mar 12, 2014
Messages
191
My Dana 20 was stuck I changed the gunk in the Dana 20 and C4 and yes I used type F in the transmission. So far so good. I found a nice quite street and put the rig in reverse for about 20 feet and put the Bronco in drive and force the dana 20 into 4 wheel drive. After working the stick it now shifts fine. On the way back home the C4 will not shift into third. I replace the vacuum hoses and topped off the C4 and it will not go from second to third.

Any ideas?

Thanks,
Jeff
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
How is reverse working now? 3rd gear clutch is also used in reverse.
 
OP
OP
J

jeff_gates

Full Member
Joined
Mar 12, 2014
Messages
191
reverse seams fine. I order a vacuum tester I will also check for vacuum leaks at the intake.
 

pcf_mark

Bronco Guru
Joined
Jun 11, 2010
Messages
3,697
Any crazy chance your shifter is out of adjustment and you have it in 2nd?
 
OP
OP
J

jeff_gates

Full Member
Joined
Mar 12, 2014
Messages
191
I checked the adjustment.
I replaced the upper and lower vacuum lines already. I pulled the upper line from the intake manifold and I could feel a good vacuum, and I put suction on the modulator and it held and no fluid at the modulator. I was going to remove it and check the pin.

Could I have done something when I replaced the filter?
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
99% chance of a stuck 2-3 shift valve inside the valve body. Maybe you tightened the filter screws too much. Spec is only 20 in-lbs.
 
OP
OP
J

jeff_gates

Full Member
Joined
Mar 12, 2014
Messages
191
I have been some research, could the dana 20 be in the wrong position? This rig has been messed with over the last 48 years the old shifter is gone as well as the shift knob. Could it be in 2H? When I put it in 1st it wanted to a shift at 7 mph or so.
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
I have been some research, could the dana 20 be in the wrong position? This rig has been messed with over the last 48 years the old shifter is gone as well as the shift knob. Could it be in 2H? When I put it in 1st it wanted to a shift at 7 mph or so.

Shouldn't matter if tcase is in high or low. You should be able to detect both gear changes in the C4. If you have a tach start out in 2nd and shift to drive when at a steady speed and see if the rpm drops.
 
OP
OP
J

jeff_gates

Full Member
Joined
Mar 12, 2014
Messages
191
It was the dana, it shifted from 1st 2second so soon that I could not detect it. It seams that if I pull the stick all the way back, that is where it wants to be.
 
Top