• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

hand E-Brake.

gunnibronco

Contributor
Sr. Member
Joined
Apr 13, 2008
Messages
628
Loc.
Gardnerville, NV
So my JK handle has a broken cable, and the cable does not seem to be sold separate from the handle.

I'm going to hope/see if the TJ cable will fit into the JK handle (or maybe the stock EB cable-probably not). If not, I'm going to look into a custom cable. I'm not sure what that will cost, or if its worth it to go that route.

I would think the stock EB cable would be too long to run a brake located near the center console.
 

Tedster100

Chairman of the Bored
Joined
Aug 25, 2010
Messages
1,762
I picked up one of these because it looks like you could mount in different locations under the dash. I might even weld a bracket to the roll cage and mount it there. $27 shipped on e-bay for a used one. Pull it out and it ratchets, turn the handle to release. 65-66 mustang I believe.
 

Attachments

  • e-brake.jpg
    e-brake.jpg
    5.9 KB · Views: 104

markw

Contributor
Bronco Guru
Joined
Sep 10, 2009
Messages
2,066
Butting in here. Does anyone make a drive line disc brake kit? I have Wilwood rear discs no E-brake and don't want to change them out if possible. Thanks, Mark
 

bronconut73

Bronco Guru
Joined
Aug 7, 2012
Messages
9,919
Butting in here. Does anyone make a drive line disc brake kit? I have Wilwood rear discs no E-brake and don't want to change them out if possible. Thanks, Mark

There is one for the Jeep Dana 20 but I am told it will not work for us.

Old Landcruisers have one but I know of no one who was able to make it work.

Let us know if you find one.

I was wondering about a separate small mechanical caliper and bracket for each rear rotor.
I could swear I have seen this set up somewhere.
Two calipers at each rear rotor, one big/main hydraulic caliper and one small mechanical caliper for the emergency brake.
 

Rustytruck

Bronco Guru
Joined
Feb 24, 2002
Messages
10,872
I picked up one of these because it looks like you could mount in different locations under the dash. I might even weld a bracket to the roll cage and mount it there. $27 shipped on e-bay for a used one. Pull it out and it ratchets, turn the handle to release. 65-66 mustang I believe.

I had one in my 67 Mustang and kept braking the handle until I started pulling directly at the shaft. Pulling only on the handle, the handle's steel inside would bend and then break. Somebody probably makes a billet handle by now.
 

markw

Contributor
Bronco Guru
Joined
Sep 10, 2009
Messages
2,066
I did some research and made a couple of calls on the driveline brake. High Angle Drivelines will supply a rotor and caliper but no mounting bracket. He wasn't encouraging. Tom Woods referred me to Parts Mike. They do make a kit which requires a 31 spline Advance Adapters D20 output shaft. Found an earlier thread from Jeff10 with pics of parts but no final outcome so I don't know if he made it work or not. Mark
 
Top