• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Vacuum vs compression

Izzy

Bronco Guru
Joined
Sep 5, 2009
Messages
2,430
Loc.
Texas
When diagnosing an engine, the vacuum test showed perfect numbers. Is there any value or need to do a compression test or does the fact that the vacuum test passed with flying colors also show that compression is good?
 

DJs74

Bronco Guru
Joined
Apr 1, 2014
Messages
1,135
When diagnosing an engine, the vacuum test showed perfect numbers. Is there any value or need to do a compression test or does the fact that the vacuum test passed with flying colors also show that compression is good?

How was the vacuum test performed? Good vacuum is a product of good compression but monitoring vacuum on a gauge while the engine is running is giving an indication of average vacuum of 8 cylinders. Any fluctuation or flutter in the vacuum gauge needle would be a sign that one or more cylinders might have a problem. If you are wanting to know for sure about your engines compression to decide on a rebuild or whatnot, I'd just check the compression on each cylinder and not try to extrapolate results, then you know what each cylinder is measuring exactly

DJs74
 

phldwsnoc1

Jr. Member
Joined
Feb 13, 2012
Messages
81
Loc.
Jarrettsville, MD
More questions

Running intake vacuum is a good indicator of engine health, but without knowing what exactly is being diagnosed and what your "perfect numbers" were it's hard to say what else is needed. Most street engines should produce stable vacuum of 18 or more at hot idle. Good luck!
 
OP
OP
Izzy

Izzy

Bronco Guru
Joined
Sep 5, 2009
Messages
2,430
Loc.
Texas
The reason for the question is I have a new issue where the engine dies as soon as I put it in drive. It runs great in idle and reverse but dies in drive. First thought was a vacuum leak.

I put a gauge on the manifold and it reads a very steady 20 with no fluctuation at all. I am wanting to avoid a compression test because I have the BCB Headers and you cannot get to all of the plugs with the headers on. I don't want to pull the headers if I don't have to.

I don't have a need to do a compression test other than curiosity of the engine but if the vacuum test shows a good engine, I just wanted to confirm that negates any need to do a compression test. I followed some instructions online for doing a vacuum test and it suggests a good running engine.

Again, this was more of a curiosity question.
 

DJs74

Bronco Guru
Joined
Apr 1, 2014
Messages
1,135
The reason for the question is I have a new issue where the engine dies as soon as I put it in drive. It runs great in idle and reverse but dies in drive. First thought was a vacuum leak.

I put a gauge on the manifold and it reads a very steady 20 with no fluctuation at all. I am wanting to avoid a compression test because I have the BCB Headers and you cannot get to all of the plugs with the headers on. I don't want to pull the headers if I don't have to.

I don't have a need to do a compression test other than curiosity of the engine but if the vacuum test shows a good engine, I just wanted to confirm that negates any need to do a compression test. I followed some instructions online for doing a vacuum test and it suggests a good running engine.

Again, this was more of a curiosity question.

Idling fine in neutral and stalling in gear (under load) does sound like a classic vacuum leak. probably check all your vacuum lines and re-torque the intake manifold in the proper sequence. Also, check your vacuum line to the modulator valve and vacuum ports around the rear of the carburetor


DJs74
 
Top