ribbits
Jr. Member
- Joined
- Jan 21, 2015
- Messages
- 130
"The special washers are critical to use and are orientation specific, they have a stepped shoulder diameter and must be installed correctly - large diameter down first, smaller diameter against the nut. The rocker stud is stepped and has a larger diameter at the head than at the thread, the washer has the stepped hole so it clears the unthreaded shank portion of the stud but has a tight fit on the 5/16 thread."
Also,,If you get a magnifying glass you can see has a small letter "T" stamped on the small diameter side and I'm assuming that stands for top "TOP"..
Thanks again
Also,,If you get a magnifying glass you can see has a small letter "T" stamped on the small diameter side and I'm assuming that stands for top "TOP"..
Thanks again











