TNcowboy
Full Member
- Joined
- Aug 29, 2019
- Messages
- 220
I've got a '67 Bronco with a stock 170...1100 carb and load a matic distributor
The idle is slightly rough, but barely perceptible. It does buck and surge when either accelerating or cruising.Vacuum is 17.5 and has a very slight needle wobble...less than an inch of vacuum. Timing is set a 6 degrees.
I've rebuilt the carb. When I did I noticed that the power valve was stuck open. I was able to lube it and get it to move freely. I changed rotor cap wires and plugs. I've installed a Petronix ignitor. The distributor diaphragm is working as it should. The old coil primary circuit was out of spec so I changed it out to a petronix 1.5 ohm unit I changed out the fuel pump and fuel tank to a 23 gallon. The truck had varnish old gas in it so I changed the pump as a precaution. I installed a fuel regulator because the pump is putting out almost 9 psi...now 4.5 psi
This weekend I changed out the spark plugs again, warmed it up and drove it around the farm...still surging. Back at the shop I pulled the plugs..see pic . Plug 1 still looked new..insulator still white, plug 2 had a little color to it, plugs 3 and 4 were carbon fouled, plug 5 had a brown tone, plug 6 did as well but slightly lighter. This plug pattern is just weird and the only thing I can think of is I've got valve issues in holes 3 and 4.
I'm going to do a compression check but was wondering if you all had any insight into this
I've also posted this at Fordsix.com
Thanks
The idle is slightly rough, but barely perceptible. It does buck and surge when either accelerating or cruising.Vacuum is 17.5 and has a very slight needle wobble...less than an inch of vacuum. Timing is set a 6 degrees.
I've rebuilt the carb. When I did I noticed that the power valve was stuck open. I was able to lube it and get it to move freely. I changed rotor cap wires and plugs. I've installed a Petronix ignitor. The distributor diaphragm is working as it should. The old coil primary circuit was out of spec so I changed it out to a petronix 1.5 ohm unit I changed out the fuel pump and fuel tank to a 23 gallon. The truck had varnish old gas in it so I changed the pump as a precaution. I installed a fuel regulator because the pump is putting out almost 9 psi...now 4.5 psi
This weekend I changed out the spark plugs again, warmed it up and drove it around the farm...still surging. Back at the shop I pulled the plugs..see pic . Plug 1 still looked new..insulator still white, plug 2 had a little color to it, plugs 3 and 4 were carbon fouled, plug 5 had a brown tone, plug 6 did as well but slightly lighter. This plug pattern is just weird and the only thing I can think of is I've got valve issues in holes 3 and 4.
I'm going to do a compression check but was wondering if you all had any insight into this
I've also posted this at Fordsix.com
Thanks











