MonsterBIlly
Sr. Member
- Joined
- Dec 17, 2015
- Messages
- 461
I have a new 408 Blueprint engine. It has holes in both valve covers for oil filler/paver. I have a filler on one side and a vent in the other. The vent I have has a small filter like a k&n. I am getting a lot of oil blowing out the vent and also around the oil filler. So much so that it gets thrown in the header and smokes.
Should I install a pcv valve and take the hose to an intake port? I currently have the intake port plugged. I do not have a air filter with a pcv port. I could buy a bulkhead fitting and do it that way rather than an intake port.
Not sure why I have so much blow by but I do drive it hard.
Should I install a pcv valve and take the hose to an intake port? I currently have the intake port plugged. I do not have a air filter with a pcv port. I could buy a bulkhead fitting and do it that way rather than an intake port.
Not sure why I have so much blow by but I do drive it hard.











