• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Traction-Lok Front Axle Experiences?

f2502011

Sr. Member
Joined
Feb 19, 2011
Messages
380
From what I can tell, Ford offered the option of a limited slip front axle in their 4x4s off and on from the 60s-> early 80s. I do think the new Tremor has some sort of limited slip front, but there's much better products now so it likely does a good job. Most every manufacturer does electronic lockers front and rear now. I don't think any of the other big 3 did the limited slip front during the 60s->early 80s, but I could be wrong. I've always been curious as to how well this worked, why it was sporadically offered and a rarely chosen option. Tried to research many times, but can't really find any actual data, experiences, videos about this option, so I wanted to see if any of you have first hand experience with it? Was it dangerous, such as when driving in slick snow or mud on the side of a hill would it walk it's way sideways vs moving forward or was it very beneficial? Did it work well on rough terrain, rocks, ruts, terrain with lots of articulation or was it essentially a useless option? Bronco's designated for Stroppe conversion as dealer stock orders vs. special orders were spec'd with 4.11 limited slip rear axles, but not the front limited slip. I would think that anything Stroppe would be equipped/ordered with every available traction aiding option like a front traction lok unless there was a good reason not to get it. I would like to know those reasons.
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
I think this is going to be one of those “all of the above“ options.
They were very been official for some, and dangerous for others. Yes to the finicky side hill action and yes to the icy road dilemma. But at the same time having that extra wheel turning could get you out of a scrape where you couldn’t without it.
Why didn’t everybody order one? For those reasons and more. Cost for another one, even though it was probably only a $45 or slightly higher option at the time.
And I bet 90% of even bronco buyers didn’t even know that one was available as an option, or if they did, probably didn’t even know what a limited slip was!
That’s if they even bothered to look. Or even had the opportunity if just buying right off the lot. In those cases it was up to the dealer to order it.

Not sure why ford didn’t offer them all years, but here again it could be multiple reasons. Cost, availability, liability, perceived lack of interest from customers, etc.
 

stevew

Bronco Guru
Joined
Jun 21, 2001
Messages
2,123
Loc.
Elliston Montana
From what I can tell, Ford offered the option of a limited slip front axle in their 4x4s off and on from the 60s-> early 80s. I do think the new Tremor has some sort of limited slip front, but there's much better products now so it likely does a good job. Most every manufacturer does electronic lockers front and rear now. I don't think any of the other big 3 did the limited slip front during the 60s->early 80s, but I could be wrong. I've always been curious as to how well this worked, why it was sporadically offered and a rarely chosen option. Tried to research many times, but can't really find any actual data, experiences, videos about this option, so I wanted to see if any of you have first hand experience with it? Was it dangerous, such as when driving in slick snow or mud on the side of a hill would it walk it's way sideways vs moving forward or was it very beneficial? Did it work well on rough terrain, rocks, ruts, terrain with lots of articulation or was it essentially a useless option? Bronco's designated for Stroppe conversion as dealer stock orders vs. special orders were spec'd with 4.11 limited slip rear axles, but not the front limited slip. I would think that anything Stroppe would be equipped/ordered with every available traction aiding option like a front traction lok unless there was a good reason not to get it. I would like to know those reasons.
I ran Fords LS front & rear for about 20 years in my 98% off road use Bronco . Plowed ( on 33's ) , trails , mud , rocks ( not crawling ) minimal pavement & it worked flawless . Did everything I wanted it to do .
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,111
Worked fine in AZ. Until the Dana 30 exploded. Even after it blew up I was still cruising the cinders with one front tire spinning but not the other.
 

MarsChariot

Contributor
Planetary Offroader
Joined
Oct 12, 2004
Messages
2,605
Loc.
Albuquerque, New Mexico
I have had 4.11 axles with factory TracLok diffs in the front and rear on the '71 (DANA 44) for 45 years now. I have not experienced anything significant in the way of problems that I know of. I did hear for many years that it might create some odd self steering behavior in very low traction situations like snow. However, I did a lot of snowy mountains and I never had any trouble; you just adjust for it anyway given the traction and steering are already squirrly on deep snow. The only other thing that may be applicable, and I do not know if this is actually a problem: I did have way more difficulty unlocking the front hubs after a run than any other Bronco I have used. I always figured that the different sides were somehow getting a little more "bound up." But other than that, they are fine from my several decades of experience.
 

SHX669

Bronco Guru
Joined
Jan 9, 2009
Messages
1,997
I also had a late '71 with D -44 and trac lok front axle . I liked it and never had any issues with it . I think they were only " locked up " about 50% .
 

Timmy390

Contributor
Bronco Guru
Joined
Jan 1, 2011
Messages
5,948
Loc.
Conway, AR
I have one in my D44 now....but I'm street 99% of the time....When I do lock it in....no issues.....Moved around some pontoon boat trailers (tight spaces my buddies 2500HD couldn't go) in loose dirt and gravel just before my teardown to install my M5R2. Worked great.......Had it for 6 plus years now...maybe more......

Tim
 

jamesroney

Contributor
Bronco Guru
Joined
Sep 11, 2007
Messages
2,612
Loc.
Fremont, CA
I don't think any of the other big 3 did the limited slip front during the 60s->early 80s, but I could be wrong.

GM - Chevy M1031 and M1028 pickup. Dana 60 limited slip front.
Willys / Kaiser / AMC / Chrysler / Daimler / Fiat / Stellantis / GAC-FCA - M38-A1 USMC. Dana 25 limited slip front.
International Harvester - Scout 80. Dana 27 Limited slip front.

All of the OEM's seem to know how to put a limited slip up front. (except dodge for some reason???)
 

bmc69

Contributor
Bronco Guru
Joined
Jun 11, 2004
Messages
12,015
I used to drive in a lot more snow than we get these days. Back when I did drive in it a lot, including snow plowing, having an LS in the front was a detriment in several respects, including simply trying to avoid an unexpected 180-360 spin when driving on harder pack in 4x4.

I've been exclusively using ARBs in front, going back about 25 years now.
 

raleigh_bronco

Bronco Guru
Joined
Sep 25, 2002
Messages
1,567
I installed a Detroit truetrac in the rear and liked it so much that I swapped out the D30 with a 44 and added another truetrac Up front. No traction issues, steering is easy. I love the setup. Also running 4:11s.
 

knack

Contributor
Sr. Member
Joined
Feb 2, 2007
Messages
877
I have had 4.11 axles with factory TracLok diffs in the front and rear on the '71 (DANA 44) for 45 years now. I have not experienced anything significant in the way of problems that I know of. I did hear for many years that it might create some odd self steering behavior in very low traction situations like snow. However, I did a lot of snowy mountains and I never had any trouble; you just adjust for it anyway given the traction and steering are already squirrly on deep snow. The only other thing that may be applicable, and I do not know if this is actually a problem: I did have way more difficulty unlocking the front hubs after a run than any other Bronco I have used. I always figured that the different sides were somehow getting a little more "bound up." But other than that, they are fine from my several decades of experience.
X2 on their being more difficult to unlock. Seemed better if I made sure to drive in a straight line for 50 feet before getting out to operate the hubs. Stock Ford hubs.
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,111
I really liked the old Mile Marker hubs. had a slick pre-selector built in. hubs bound up? just drive and when the bind releases, so does the hub.
 
OP
OP
F

f2502011

Sr. Member
Joined
Feb 19, 2011
Messages
380
Any steering or other drivability issues driving around on dry ground with hubs locked in and not in 4x4?
 

bam

Contributor
Full Member
Joined
Jun 11, 2017
Messages
291
Loc.
Laurel, Ms
From what I can tell, Ford offered the option of a limited slip front axle in their 4x4s off and on from the 60s-> early 80s. I do think the new Tremor has some sort of limited slip front, but there's much better products now so it likely does a good job. Most every manufacturer does electronic lockers front and rear now. I don't think any of the other big 3 did the limited slip front during the 60s->early 80s, but I could be wrong. I've always been curious as to how well this worked, why it was sporadically offered and a rarely chosen option. Tried to research many times, but can't really find any actual data, experiences, videos about this option, so I wanted to see if any of you have first hand experience with it? Was it dangerous, such as when driving in slick snow or mud on the side of a hill would it walk it's way sideways vs moving forward or was it very beneficial? Did it work well on rough terrain, rocks, ruts, terrain with lots of articulation or was it essentially a useless option? Bronco's designated for Stroppe conversion as dealer stock orders vs. special orders were spec'd with 4.11 limited slip rear axles, but not the front limited slip. I would think that anything Stroppe would be equipped/ordered with every available traction aiding option like a front traction lok unless there was a good reason not to get it. I would like to know those reasons.
only 314 with d44 limited slip in 1972
 

Attachments

  • A19F4612-1403-40C1-B5ED-C716FE5DA335.png
    A19F4612-1403-40C1-B5ED-C716FE5DA335.png
    245.2 KB · Views: 125

jamesroney

Contributor
Bronco Guru
Joined
Sep 11, 2007
Messages
2,612
Loc.
Fremont, CA
only 314 with d44 limited slip in 1972
Watch out...Those Marti statistics are hard to interpret.

Your "vehicle" is a U14 Ford Pickup Truck. Those stats won't include U15 wagon data. So yes...314 pickups with D44 limited slip.
 

svobronco

Contributor
Sr. Member
Joined
May 31, 2011
Messages
350
Any steering or other drivability issues driving around on dry ground with hubs locked in and not in 4x4?
You won't notice it. Power needs to be put TO a TracLoc to make it lock up, free spinning won't do anything. I run a Detroit in the front, with hubs locked and out of 4x it drives just fine.
I had a '78 with factory TracLoc's front and rear. I blew a rear driveshaft once and had to drive it home in front wheel drive....that was scary
 

fordfan

Bronco Guru
Joined
Sep 13, 2009
Messages
3,592
The best is a selectable locker. I have ran ARBs in both ends of my 'working' Bronco for years without issue. It's locked when you need it and open when you don't... It's the best of both worlds and no on the road driving issues.
 

bam

Contributor
Full Member
Joined
Jun 11, 2017
Messages
291
Loc.
Laurel, Ms
Watch out...Those Marti statistics are hard to interpret.

Your "vehicle" is a U14 Ford Pickup Truck. Those stats won't include U15 wagon data. So yes...314 pickups with D44 limited slip.
I meant to put u14 in the post, thanks for the reminder
 

Nothing Special

Sr. Member
Joined
Nov 25, 2016
Messages
848
You won't notice it. Power needs to be put TO a TracLoc to make it lock up, free spinning won't do anything. I run a Detroit in the front, with hubs locked and out of 4x it drives just fine.
I had a '78 with factory TracLoc's front and rear. I blew a rear driveshaft once and had to drive it home in front wheel drive....that was scary
Is that true? I don't have a lot of experience with TracLocs, but I was thinking they are a fairly conventional clutch-type limited slip which has friction between the two sides all the time. I know when I had an almost completely worn out TracLoc in the rear of my pickup it was difficult to turn one wheel by hand if the other wheel wasn't also jacked up and the truck in neutral.

If that's the case then you might notice it being difficult to turn the steering wren sitting still with the hubs locked. Likely wouldn't be as noticeable when moving

The Detroit is a completely different animal. It will always unlock when one tire wants to overrun, so that won't cause any bind-up when trying to turn the steering while stopped with the hubs locked.
 

sprdv1

Contributor
REBEL
Joined
Mar 8, 2007
Messages
81,996
I ran Fords LS front & rear for about 20 years in my 98% off road use Bronco . Plowed ( on 33's ) , trails , mud , rocks ( not crawling ) minimal pavement & it worked flawless . Did everything I wanted it to do .
yes sir.....
 
Top