Thanks Oldtimer. That’s good info.
Maybe that block at the end of the wire is a simple splice then and not a fusible link section.
I guess there’s one way to find out.
Since that wire is all toasted anyway, pull what’s good out of the harness and short it out!
Using suitable safety precautions and equipment of course…
Or not perhaps. If that section near the starter relay is still good you could retain the factory splice with the yellow wire and splice in new segment of 10 gauge wire between it and the rest of the vehicle.
It needs to be replaced anyway, but any wire that still usable can be.
Personally though I would eliminate it and run all new from start to finish.
And speaking of all new, those grounds look nicely done on the wheel well. Including taking the paint off underneath.
But unless that ring terminal is soldered I would cut off the yellow insulator and put shrink tubing on instead.
You don’t want it deteriorating over time in the under-hood weather.