Out driving the Bronco yesterday evening I started feeling a vibration (or something of that nature) at around 50 mph. No unusual noises but it could be felt. This morning I checked the torque on the wheels to make sure they were tight. Checked the rear driveshaft and all of it's fasteners. everything from the transfer case back is new, driveshaft, new 3rd member, new wheel bearings and seals in the rear axle and everything to do with the rear brakes is new as well. 3.5 inch lift with 6 degree shims at the spring pack. I do not have a front driveshaft in it at this time but I did check to make sure the transfer case was in 2H and not 4H or 4L. I took some pictures of the rear driveshaft would like some opinions about the angle if you can tell from looking at them. Sorry if the pictures are hard to see.











