- Joined
- Oct 11, 2007
- Messages
- 564
As I’m putting my cut and turned 73 bronco
Dana 44 back together, I’m trying to do all the stuff I’ve never done in the past (example) I’m trying to pre load the new ball joints correctly. I’ve set the adjuster to get a straight pull of 23-25 lbs. once I torqued the top ball joint nut to 100ft lbs, the hubs are extremely hard to turn side to side. I understand I should not pay attention to these readings after I torqued the top nut but in order to move the hub it takes around 50ft lbs of pull to move each hub separately. Does this sound normal? Again this is my first time actually trying to set ball joint preload.
Dana 44 back together, I’m trying to do all the stuff I’ve never done in the past (example) I’m trying to pre load the new ball joints correctly. I’ve set the adjuster to get a straight pull of 23-25 lbs. once I torqued the top ball joint nut to 100ft lbs, the hubs are extremely hard to turn side to side. I understand I should not pay attention to these readings after I torqued the top nut but in order to move the hub it takes around 50ft lbs of pull to move each hub separately. Does this sound normal? Again this is my first time actually trying to set ball joint preload.











